Step-by-Step Transfer Instructions
1. Print your design in mirror image mode onto the frosted side of the A-Film. Load the A-Film into the printer with the frosted side (print side) face up.
2. Please note, that the B-Paper is slightly smaller than the A-Film on purpose. This prevents your heat press from getting dirty.
3. Place the A-Film directly on the top of the lower platen (printed/frosted side showing up).
4. Place the B-Paper (coated side down) on top of the A-Film. ✨ PRO TIP: Fold over a small corner of the B-Paper to assist with getting the marry peel started later on.
5. Place a sheet of parchment paper over the B-Paper to avoid sticking.
6. Press all together using the parameters listed in the chart at the top of the page depending upon the printer you own.
7. When the time is up, open the heat press and remove the parchment paper. Begin your peel 5-10 seconds after opening your heat press. Do not wait any longer.
Separate the B-Paper from the A-Film without lifting them up from the lower platen of your heat press to avoid heat loss. Work in a SLOW AND FLUID motion. DO NOT PAUSE OR STOP once you begin the peel process.
8. Trim your design to remove the safety box and any residue left behind by the B-Paper.
9. Place the textile/substrate on the lower platen of the heat press. Pre-press it for 5-10 seconds to remove any wrinkles or moisture.
10. Using a finishing sheet or parchment paper for protection, press the transfer following the chart for the suggested temperature setting.
💡 Tip: If you are losing color vibrancy when transferring to textiles, reduce your application temperature.
11. Carefully remove the textile/substrate from the heat press and allow to cool before peeling away the A-Film. Only remove the A-Film after it is absolutely cold.
Failure to do so may result in a faulty transfer. Start from a corner with the most toner coverage and remove the A-Film in one, rapid motion (like a bandage).
12. To ensure wash-ability and a matte finish, re-press your textile/substrate with a piece of parchment paper for 20 seconds at high pressure (a 8 or 9).
- For a shiny finish, use a Teflon sheet.
- For a textured finish, use a Flexible Finishing Sheet.
🛠️ Technical Specifications & Setup
PRINTER SETTINGS
We recommend printing from Digital Heat FX Print Optimizer (.PNG, .EPS, .PSD, .TIFF, .PDF, .JPG, etc.).
TEXTILE SELECTION
Always select a less stretchy fabric (no spandex or lycra) to prevent cracking when pulling/stretching the fabric apart.
⚠️ Heat Press Requirements
1. Remove Teflon sheets from the upper and lower platen. Teflon absorbs too much heat and leads to inconsistent results.
2. Silicone Pad: Ensure it is faultless and glued to the lower platen to avoid horizontal "slide" movement during the transfer.
3. Pre-Heat: Always pre-heat the lower platen until hot before beginning work or after long breaks.
Questions? Contact Support Today
📞 877-793-3278
CARE INSTRUCTIONS: Cold wash inside out, delicate cycle. Low dryer or hang dry. Cover with parchment if ironing.
